Iapp (Inter-Access-Point Protocol) Commands - Nortel BayStack 660 Use Manual

Using the BayStack 660 Wireless LAN Access Point

IAPP (Inter-Access-Point Protocol) Commands

The IAPP commands enable you to configure and to display IAPP attributes.
The IAPP commands are:
• iapp interval— sets IAPP broadcast interval
• iapp multi-vendor— enables or disables the use of multi-vendor IAPP
• iapp show— displays IAPP attributes
The syntax for the IAPP commands is:
iapp interval < num_sec >
iapp multi-vendor {enable | disable}
iapp show
where:
num_sec is number of seconds.
6-14
203939-B