Using the BayStack 660 Wireless LAN Access Point
Figure 6-11
Figure 6-11.
System Commands
The system commands enable you to configure and to display system attributes.
The system commands are:
•
sys essid— sets the ESSID
•
sys ether-link-mode— sets Ethernet link model
•
sys gateway— sets gateway
•
sys ip-address— sets system IP address and net mask
•
sys ip-on-wport— enables or disables IP processing on wireless port
•
sys load-image— upgrades Access Point firmware
6-20
shows examples of the SNMP commands.
SNMP Commands Example
203939-B