Nortel BayStack 660 Use Manual page 139

• sys name— sets Access Point name
• sys show— displays system attributes
The syntax for the system commands is:
sys essid < ess_id_name >
sys ether-link-mode {10base_2 | 10base_t}
sys gateway < gtw_ip_addr >
sys ip-address < sys_ip_addr > < sys_net_mask >
sys ip-on-wport {enable | disable}
sys load-image < file_name > < tftpd_ip_addr >
sys name < sys_name >
sys show
where:
ess_id_name is the ESS ID for wireless LAN.
gtw_ip_addr is the IP address of the gateway.
sys_ip_addr is the IP address of the access point.
sys_net_mask is the network mask for the access point.
file_name is the access point firmware file name.
tftpd_ip_addr is the IP address of the TFTP server.
sys_name is the name for the access point.
203939-B
Command Line Interface
6-21