Auto Reverse Document Feeder (A663) Installation Procedure - Ricoh FT5535 Service Manual

11.4 AUTO REVERSE DOCUMENT FEEDER (A663)
INSTALLATION PROCEDURE
[A]
[E] [D]
[F]
[C]
CAUTION
Unplug the copier power cord before starting the following procedure.
1. Remove the strips of tape [A].
2. Attach the sponge retainer [B] to the top cover of the copier as shown.
3. Tighten the two stud screws [C].
4. Mount the ARDF by aligning the holes [D] in the ARDF and the stud
screws [C], then slide the ARDF to the front as shown.
NOTE: When mounting the ARDF, hold it by hand as shown in the
illustration. Holding it in another way may damage the ARDF.
5. Screw the two stud screws [E] into the holes [F] and tighten them.
6. Remove the plug [J] from the rear of the copier.
7. Connect the connectors [G] into the socket on the rear of the copier.
8. Attach the symbol explanation decal [H] and the combine originals
explanation decal [I] to the ARDF as shown (except for the A207 copier).
SM
CÓPIA NÃO CONTROLADA
[A]
[J]
A663I500.wmf
[E]
[G]
A663I502.wmf
1-49
CÓPIA NÃO CONTROLADA
INSTALLATION
[B]
[I] [H]
A663I501.wmf
A663I503.wmf
A207/A208/A211