Ricoh FT5535 Service Manual page 596

REPLACEMENT AND ADJUSTMENT
– Front Helical Wheel –
[G]
[C]
[E]
[B] [D]
[N]
[I]
1. Place the bearing [A] over the stud [B] on the bottom plate then thread
timing belt-918XL [C] and timing belt-300XL [D] around the pulley.
2. Place the pulley [E] on the bearing. The direction of the pulley should be
as shown in the illustration.
3. Feed the helical wheel through the wheel sensor actuator [F]. Leave the
Allen screw [G] loosened.
4. Place the helical wheel [H] in the pulley [E]. Leave the Allen screws [I]
loosened.
5. Place the bracket with a bushing [J] on top of the helical wheel, then
install and slightly tighten the four screws [K].
6. Place a 0.4 mm thickness gauge [L] between the helical wheel and the
bushing on the bracket. While holding the bushing down on the helical
wheel [H], tighten the four screws [K].
7. Hook tension springs [M] and [N] then tighten the screw [O].
8. Install the wheel sensor bracket [P].
A207/A208/A211
CÓPIA NÃO CONTROLADA
[F]
[J]
[H]
[O]
[H]
[A]
A664R535.wmf
[P]
3-44
CÓPIA NÃO CONTROLADA
[K]
[K]
[L]
A664R536.wmf
[M]
[I]
A664R537.wmf
SM