Ricoh FT5535 Service Manual page 64

24. Enter SP mode as follows:
1) Press the "Clear Modes" key.
2) Enter "107" using the numeric keys.
3) Hold down the "Clear/Stop" key for more than 3 seconds.
NOTE: When SP mode is selected, "1" blinks in the 3rd digit of the copy
counter, the Auto Image Density indicator starts blinking, and the
reduce/enlarge indicator turns off.
25. Perform the "TD sensor initial setting" SP mode as follows:
1) Enter "2" and press the "Enter" key.
2) Enter "214" and press the "Enter" key.
3) Press the "Start" key.
NOTE: The machine will automatically stop when TD sensor initial
setting is completed. (It takes about 2.5 minutes.)
26. Perform the "Compulsory toner supply" SP mode as follows:
1) Press the "Clear Modes" key twice.
2) Enter "2" and press the "Enter" key.
3) Enter "207" and press the "Enter" key.
4) Press the "Start" key.
NOTE: The machine will automatically stop when compulsory toner
supply is completed. (It takes about 30 seconds.)
5) Compulsory toner supply must be performed twice in order to supply
enough toner to the toner hopper, so press the "Start" key again.
- A156 copier only -
Select the proper language for the guidance display as follows:
1) Press the "Clear Modes" key twice.
2) Enter "5" in the 3rd digit of the copy counter and press the "Enter" key.
3) Enter "910" and press the "Enter" key.
4) Enter the number for the desired language in the three-digit indicator
and press the "Enter" key.
1:English 2:French 3:German 4:Italian 5:Spanish
6:Swedish 7:Portuguese 8:Danish 9:Norwegian
10:Finnish 11:Dutch
27. Press the "Clear Modes" key three times to exit SP mode.
FSM
CÓPIA NÃO CONTROLADA
3-11
CÓPIA NÃO CONTROLADA
Rev. 7/95
A156/A160/A162