Ricoh FT5535 Service Manual page 317

Rev.10/11/95
[D]
[C] [G]
For copiers with an LCT unit: Do not
lift the copier by holding the LCT unit.
3. Set the copier [B] on the paper tray unit [C]. Align the 2 pins [D] on the
paper tray unit with the holes in the base plate of the copier.
4. Open the lower right door [E] and either the LCT [F] or the upper right
door [F] (depending on the type of copier).
5. Secure the copier to the paper tray unit with the joint bracket [G].
6. Remove the Plug [P] from the rear of the copier.
7. Connect the cable [H] and optic fiber [I].
8. Attach the support brackets [J] to the bottom of the paper tray unit as
shown (4 screws).
CAUTION
If you do not do this, the machine may fall forwards if all the paper
trays are pulled open.
9. Pull out the paper tray and load paper into it. (The paper size and
direction for each tray should be designated by a customer.)
NOTE: The side and rear fences should be properly positioned.
10. Turn on the main switch.
11. Enter the proper paper size for each paper tray by following the
instructions in the copier's manual.
12. Attach the appropriate tray decals [K] which are included in the
accessory box of the main copier.
13. Check the machine's operation and copy quality.
A156/A160/A162
CÓPIA NÃO CONTROLADA
[B]
Fiber Connector Plug [P]
[F]
[I]
[H]
[D]
[E]
9-6
CÓPIA NÃO CONTROLADA
[J]
[K]
FSM