Ricoh FT5535 Service Manual page 595

– Installation –
NOTE: After installing the helical wheels, perform the helical wheel
alignment, which is explained later.
– Rear Long Helical Wheel –
[B]
[C]
A664R533.wmf
1. Place the bearing [A] over the stud on the bottom plate.
2. Insert the helical wheel [B] into the pulley [C], then place the helical wheel
on the bearing [A].
3. Place the bracket with the bushing [D] on top of the helical wheel, then
install and slightly tighten three screws [E].
4. Place a 0.4 mm thickness gauge [F] between the helical wheel [B] and
the bushing [D] on the bracket. While holding the bushing down on the
helical wheel, tighten the three screws [E].
SM
CÓPIA NÃO CONTROLADA
[A]
0.4 mm
[B]
3-43
CÓPIA NÃO CONTROLADA
REPLACEMENT AND ADJUSTMENT
[D]
[F]
A664R534.wmf
A207/A208/A211
[E]