Quenching Lamp Replacement - Ricoh FT5535 Service Manual

4.7 QUENCHING LAMP REPLACEMENT

[A]
1. Remove the following parts:
•
Development unit
•
Drum unit
2. Lower the transfer belt unit and place a sheet of paper [A] over the transfer
belt.
NOTE: This step prevents the quenching lamp from damaging the transfer
belt if it falls.
3. Disconnect the connector [B] (CN108) from the main board.
4. Remove the screw [C] and push the quenching lamp [D] halfway in from the
front until its front end does not fall down.
5. Remove the quenching lamp [D] from the back of the copier.
A156/A160/A162
CÓPIA NÃO CONTROLADA
[B]
[C]
5-24
CÓPIA NÃO CONTROLADA
[D]
FSM