Lead Edge Erase Margin Adjustment; (Sp2-101-001); Lens Horizontal H; (Sp4-011-001~009) - Ricoh FT5535 Service Manual

10.15 LEAD EDGE ERASE MARGIN ADJUSTMENT

(SP2-101-001)

When:
Purpose:
Adjustment Standard:
How:
SP2-101-001: Lead Edge Erase
0 - 32 (default = 16, – 8.0 mm to + 8.0 mm), 0.5 mm per step
10.16 LENS HORIZONTAL H.P. ADJUSTMENT

(SP4-011-001~009)

When:
Purpose:
Adjustment standard:
How:
1. Make a full size copy from each paper feed station.
2. Check whether side-to-side registration is within the adjustment standard.
FSM
CÓPIA NÃO CONTROLADA
If the lead edge erase margin is not within the
adjustment standard.
To maintain a proper lead edge erase margin.
2.5 ± 1.5 mm (0.1 ± 0.06")
SP2-101-001 changes the erase lamp off timing.
If side-to-side registration is not within the
adjustment standard.
To maintain proper side-to-side registration from
all feed stations.
0 ± 2 mm (0 ± 0.08")
SP4-011-001~009 changes the lens horizontal
home position.
SP4-011-001~007 and 009 change the lens
horizontal home position used for certain units
(see step 3 below). If registration is not within
the standard when using a certain unit, use one
of these SP modes.
SP4-011-008 is the base adjustment made in
the factory. If this setting is changed by a small
amount, all other SP4-011 settings change
automatically by the same amount. Use this if
the image shift direction (to the front or to the
rear) is the same from all paper feed stations.
5-63
CÓPIA NÃO CONTROLADA
Rev. 7/95
A156/A160/A162