Erase Lamp Replacement - Ricoh FT5535 Service Manual

4.8 ERASE LAMP REPLACEMENT

[A]
1. Remove the following parts:
•
Development unit
•
Drum unit
•
Main board
2. Lower the transfer belt unit and place a sheet of paper [A] over the transfer
belt.
NOTE: This step prevents the erase lamp from damaging the transfer belt if
it falls.
3. Remove the screw [B] and push the erase lamp [C] halfway in from the front
until its front end does not fall down.
4. Remove the erase lamp [C] from the back of the copier.
FSM
CÓPIA NÃO CONTROLADA
[B]
5-25
CÓPIA NÃO CONTROLADA
[C]
A156/A160/A162