Ricoh FT5535 Service Manual page 338

[D]
[C]
[A]
[F]
6. Remove the M4 x 8 round head screws from the left cover of the copier
(A153/A155/A156 copiers: 2 screws [A], A157/A159/A160/A161/A162
copiers: 3 screws [A] and [B]).
7. Mount the sorter stapler mounting frame [C] on the copier as shown
(4 – M4 x 14 screws).
NOTE: When hooking the sorter stapler mounting frame on the left side
of the copier, make sure that the positioning hooks [D] on the
frame are properly inserted in the positioning holes [E] in the
copier.
8. Remove the junction gate [F] (1 snap ring) before installing the sorter
stapler. This prevents the junction gate from damaging the guide plate of
the sorter stapler mounting frame.
9. Install the sorter stapler [G] on the sorter stapler mounting frame (2 hinge
pins at the rear).
NOTE: First, lift the sorter stapler onto the support plate [H], opening the
sorter stapler about 30 degrees. Then, insert the upper stud [I]
into the upper hinge hole [J]. Finally, insert the lower stud [K] into
the lower hinge hole [L].
10. Remount the junction gate [F] (1 snap ring).
11. Connect the link lever [M] to the sorter stapler using the stepped screw
[N], then close the sorter stapler.
FSM
CÓPIA NÃO CONTROLADA
[E]
[B]
[I]
[G]
10-11
CÓPIA NÃO CONTROLADA
[J]
[K]
[N]
[M]
A156/A160/A162
[L]
[H]