Flip Assembly Removal - Sony Ericsson Z525i Working Instruction

NOTE!
8. Gently and slowly rotate the flip portion of the phone
away from the keypad until the inner portion of the
base separates from the outer base cover.
9. Locate the camera key and set it aside.
2.1.4

Flip Assembly Removal

All of the sections of the Base Disassembly preceding this section must be performed in sequential
order before the disassembly steps listed below can be performed.
Tools needed to perform the following steps:
NOTE!
1. Turn the flip/inner base assembly so that the side of
the circuit board with the SIM holder is upward.
2. Release the main flex film connection from the
circuit board using a pry tool.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
The camera key falls out of its opening
when performing the next step.
Whenever the phrase "pry tool" is used, a nylon pointer, an orangewood stick, or a front
opening tool may be used, depending on the user's preference.
Step-by-Step Instructions
Working Instruction, Mechanical
•
Pry Tool
8(115)