6. Place the keypad, keys down, into its corresponding
opening in the inner base cover.
NOTE!
•
Perform sections 2.2.1-2.2.5 of the Base Reassembly
4.6
Outer Base Cover
Replacement Procedure
To remove this part, perform sections 2.1.1 – 2.1.3 of the base disassembly. Use new part in
the place of the old part and perform the following bulleted actions before starting the
reassembly procedure.
•
•
•
To install the new part, perform sections 2.2.3 - 2.2.5 of the base reassembly.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
The keypad should be oriented so that the
shape of the keypad corresponds to the
shape of the opening in the inner base cover.
Install a new IR window in the new outer base cover. Refer to IR window installation
section for detailed instructions.
Transfer the antenna assembly, the side volume key, the Bluetooth antenna, and the RF
plug from the old outer base cover to the new one. Refer to the removal and installation
sections of any specific component whose removal and installation procedures are in
question.
Create and install a new set of labels. Refer to label installation section for detailed
instructions.
Working Instruction, Mechanical
37(115)