Sony Ericsson Z525i Working Instruction page 64

NOTE!
3. Orient the LCD assembly so that the large display is
towards the inner flip cover and the end of the LCD
assembly with the strip of flex film wrapped over it
is towards the hinge.
4. Lift the main flex film out of the way and insert the
end of the LCD assembly with flex film wrapped
over it into the LCD alignment features on the inner
surface of the inner flip cover.
5. Lift the camera module's flex film out of the way
and rotate the LCD assembly down onto the inner
flip cover so that the LCD assembly is seated within
its four alignment features on the inner flip cover.
6. Plug the LCD connector on the main flex film into
the corresponding connector on the LCD assembly.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
If there is a protective film over the large
display of the LCD assembly, remove it at
this time.
Working Instruction, Mechanical
64(115)