9. Close the phone so that the keypad is not accessible.
10. Snap the external edge of the antenna cover into
position in the outer base cover.
11. Using a torque screwdriver set to 17 N·cm with a T6
Torx® bit, install the four 1.6 X 5.1mm screws
(black colored) into the outer base cover in the
following order.
a. First, insert a screw in the screw location
b. Next, install a screw in the unoccupied screw
c. Finally, install a screw in each of the two
12. Verify that a piece of tape is mounted on the shield
can adjacent to the SIM connector as shown. If there
is not a piece of tape in this location indicated install
a piece of display tape by:
All of the sections of the base reassembly following this section must be performed in sequential
order to reassemble the base portion of the phone.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
adjacent to the RF port.
location that is adjacent to the rear speaker.
remaining screw locations that are near the
system connector.
•
Centering the display tape with the
contacts of the SIM connector and
allowing the tape to slightly overlap the
edge of the shield can.
•
Fold the tape's overlap down onto the
shield can.
Step-by-Step Instructions
Working Instruction, Mechanical
16(115)