Sony Ericsson Z525i Working Instruction page 22

7. Locate the seam where the inner flip cover and the
outer flip cover adjoin.
8. To free the clips holding the inner and outer flip
covers together, start near the hinge joint and slide
the flat end of a pry tool down each side seam to just
before the point where the style-up cover's latch
holes are located.
9. Rotate the hinge end of the outer flip cover away
from the phone approximately 20 degrees so that the
camera ring clears the camera module.
10. With the outer flip cover rotated up off of the flip 20
degrees, push the outer flip cover towards the system
connector to remove it from the phone.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Working Instruction, Mechanical
22(115)