Co-Brand Label; Co-Brand Label Removal; Co-Brand Label Installation - Sony Ericsson Z525i Working Instruction

4.39 Co-Brand Label

4.39.1

Co-Brand Label Removal

• No Disassembly required
Tools needed to perform the following steps:
*
NOTE!
NOTE!
1. Locate the co-brand label area on the inner flip cover
adjacent to hinge.
2. If an old co-brand label is present, remove it.
NOTE!
3. Using alcohol and a lint-free wipe, clean any
remaining adhesive residue from the co-brand label
area on the inner flip cover.
4.39.2

Co-Brand Label Installation

Tools needed to perform the following steps:
NOTE!
1. Using tweezers, mount a new co-brand label in the
designated area.
NOTE!
2. Once the co-brand label is correctly positioned,
carefully smooth the label into place.
•
No Reassembly required
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Style 2A ESD-safe tweezers
A " * " beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
The phrase "pry tool" indicates that a nylon pointer, an orangewood stick, or a front opening
tool may be used during this procedure depending on the user's preference.
Be careful not to scratch the inner flip cover
when removing the old co-brand label.
Use tweezers to handle the new co-brand
label once it had been removed from its
protective backing so that contamination of
the adhesive is avoided.
Make sure that all edges of the co-brand
label are within the recessed area designated
for it.
* Pry tool
•
Lint-free wipes
Step-by-Step Instructions
•
Style 2A ESD tweezers
Step-by-Step Instructions
Working Instruction, Mechanical
114(115)