Sony Ericsson Z525i Working Instruction page 108

7. Lift the main flex film out of the way and insert the
end of the LCD assembly with flex film wrapped
over it into the LCD alignment features on the inner
surface of inner flip cover.
8. Lift the camera module's flex film out of the way
and rotate the LCD assembly down onto the inner
flip cover so that the LCD assembly is seated within
its four alignment features on the inner flip cover.
9. Plug the LCD connector on the main flex film into
the corresponding connector on the LCD assembly.
NOTE!
10. Carefully slide the flex connection of camera module
into the slot in the edge of its mating connector on
the main flex film. Slide the two halves of the
connection together until the two tabs on each side of
the camera module's flex film are butted against to
the edge main flex film's connector.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Make sure that the black retaining bar on the
main flex film's camera module connection
is rotated towards the center of the
connector into a vertical orientation before
trying to insert the mating flex film.
Working Instruction, Mechanical
108(115)