Lcd Assembly Installation - Sony Ericsson Z525i Working Instruction

4.20.2

LCD Assembly Installation

If this part is being replaced, a new part should be used in the place of the old part when
performing the following steps.
Tools needed to perform the following steps:
NOTE!
1. Orient the LCD assembly so that the small display is
toward you and main flex film connector is below
the small display window.
2. Determine wether a piece of display tape is installed
over a portion of the LCD assembly's left edge. If a
piece of display tape is not installed:
a. Obtain a display tape and position it on the
b. Apply pressure to the portion of the tape that was
c. Rotate the unattached portion of the display tape
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Whenever the phrase "pry tool" is used, a nylon pointer, an orangewood stick, or a front opening
tool may be used, depending on the user's preference.
Step-by-Step Instructions
surface shown so that the upper narrow edge of
the display tape is adjacent to the bottom of the
upper series of notches in the LCD assembly's
circuit board.
just placed.
down on to the LCD assembly's circuit board
and apply pressure to the tape.
Working Instruction, Mechanical
•
Pry Tool
63(115)