Base Reassembly; Circuit Board Installation - Sony Ericsson Z525i Working Instruction

2.2

Base Reassembly

The reassembly of the base portion of this product is broken down into sections by the components
that need to be installed to perform the reassembly of the base portion. The sections that make up
the "Base Reassembly" procedure are arranged in the order that they must be performed to
properly reassemble the base portion of this product. If you have only performed a partial
disassembly of the base, just perform the appropriate reassembly sections.
2.2.1

Circuit Board Installation

Tools needed to perform the following steps:
1. Obtain the inner base cover that will be installed.
2. Inspect the portion of the inner base cover indicated
(Figure 1) using figures 2, 3, and 4 to determine if a
shim needs to be added.
a. If a shim is present (Figure 2) or if additional
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
material is present beside the opening in the side
wall (Figure3) proceed to step 3.
None
Step-by-Step Instructions
Working Instruction, Mechanical
10(115)