Flip Assembly; Flip Hinge Cover; Camera Module - Sony Ericsson P910a Working Instruction, Mechanical

4.6

Flip Assembly

The removal and installation of this part is covered in the "Disassembly" and "Reassembly"
sections of this document. Limit the amount of disassembly to only that which is needed to
remove this part. If this part is being replaced, a new part should be used in the place of the old
part when reassembling.
4.7

Flip Hinge Cover

The removal and installation of this part is covered in the "Disassembly" and "Reassembly"
sections of this document. Limit the amount of disassembly to only that which is needed to
remove this part. If this part is being replaced, a new part should be used in the place of the old
part when reassembling.
4.8

Camera Module

Tools:
•
Perform the steps of "Disassembly" section before proceeding.
1. Position a pair of blunt tip tweezers so that the
arms of the tweezers are parallel to the circuit
board and so that the cylindrical portion of the
camera is between the arms of the tweezers.
2. With the tweezers oriented as specified, grip the
camera with the tweezers and rock the camera
back in forth while lifting the camera away from
the circuit board. The camera module should
come free from the camera connector.
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
• 2A (blunt tip) ESD-safe tweezers
Step-by-Step Instructions
Working Instruction, Mechanical
24(62)