Sony Ericsson Z525i Working Instruction page 29

11. Hold the outer flip cover at approximately a 15
degree angle to the inner flip cover/LCD sub-frame
assembly and slide the camera ring end of the outer
flip cover onto the mating end of the inner flip
cover so that the latches along the end seam engage
correctly.
12. Rotate the outer flip cover down onto the inner flip
cover/LCD sub-frame assembly and snap the two
covers together by squeezing together the edges
where the two covers mate.
NOTE!
13. Hold the flip assembly together and open the phone
so that the keypad is accessible.
14. Install the 1.6 X 5.1mm screws (black colored) into
the two screw locations near the hinge joint in the
inner flip cover using a torque screwdriver set to 17
N·cm and a T6 Torx® bit.
15. Close the phone so that the keypad is inaccessible.
16. Install a 1.7 X 4.5mm screw (silver colored) into
each of the two screw locations near the camera in
the outer flip cover using a torque screwdriver set to
17 N·cm and a T6 Torx® bit.
17. If a bezel was not installed on the outer flip cover,
place a protective film over LCD assembly's small
display.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
When the two covers are correctly snapped
together, the seam should be a consistent
size all the way around.
Working Instruction, Mechanical
29(115)