Sony Ericsson Z525i Working Instruction page 94

3. Orient the circuit board so that the dome foil is
towards you and the system connector is oriented to
the bottom.
NOTE!
4. Orient the side key flex film as shown so that the
contact portion of the flex film is aligned with the
bottom of its connector on the circuit board.
5. Carefully slide the connection portion of the side key
flex film into the slot in the edge of its mating
connector on the circuit board until the flex film will
not insert any further.
6. Hold the connection together and rotate the black
retaining bar towards the main keypad dome foil so
that the retaining bar is flush with the rest of the
connector. Then press down on the retaining bar to
make sure it is completely closed.
•
Perform all sections of the Base Reassembly Procedure.
3/00021-1/FEA 209 544/597 F
©
Sony Ericsson Mobile Communications AB
Step-by-Step Instructions
Make sure that the black retaining bar on the
circuit board connector for the side key flex
film is rotated to a vertical orientation.
Working Instruction, Mechanical
94(115)