Two Post Procedure - Juniper ACX5048 Hardware Manual

Figure 33: Slide Mounting Blades into 1 U Mounting Rail
1 Rearmounting-blades
—
2 Side mounting-rails
—
9. Ensure that the router chassis is level by verifying that all the screws on the front of the rack are aligned
with the screws at the back of the rack.

Two Post Procedure

You can center mount a ACX5096 on two posts of a 19-in. rack or cabinet by using the short mounting
brackets provided with the router. Other product SKUs of the ACX5000 are not recommended for two
post installation.
To mount the router on two posts in a rack using the provided mounting kit:
1. Attach the ESD grounding strap to your bare wrist and to a site ESD point.
2. Decide whether the Field Replaceable Unit (FRU) end of the router or the port end is to be placed at
the front of the rack. Position the router in such a manner that the AIR OUT labels on components are
next to the hot aisle.
3. Align the tenmounting holes on the short mounting bracket with one of the three sets of corresponding
holes along the side of the router chassis . See
Figure 34: Attaching a Two-Post Mounting Bracket to ACX5096 Router
3 Router chassis
—
Figure 34 on page 108.
108