Mercedes-Benz EQS 350 Operator's Manual page 446

Lowering the vehicle after a wheel change
Requirements:
The new wheel has been fitted (
R
* NOTE Risk of vehicle jack becoming trap-
ped by the AIRMATIC system
If the AIRMATIC system has released air when
raising the vehicle, the jack can become trap-
ped when the vehicle is lowered.
Start the drive system. This adapts the
#
vehicle level.
Remove the jack from under the vehicle.
#
To lower the vehicle: place the ratchet onto
#
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
page 442).
/
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
an initial maximum force of 80 Nm.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
the specified tightening torque of 150 Nm.
& WARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
Ensure that the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the vehi-
#
cle. Contact a qualified specialist work-
shop and have the tightening torque
checked immediately.
Check the tyre pressure of the newly fitted
#
wheel and adjust it if necessary.
%
The following does not apply if the new wheel
1 to 5 with
is an emergency spare wheel.
Vehicles with a tyre pressure monitoring sys-
#
tem: restart the tyre pressure monitoring sys-
1 to 5 with
tem (
/
Wheels and tyres 443
page 433).