Mercedes-Benz EQS 350 Operator's Manual page 192

& WARNING Risk of burns due to repeatedly
switching on the seat heating
Repeatedly switching on the seat heating can
cause the seat cushion and seat backrest pad-
ding to become very hot.
In particular, the health of persons with limited
temperature sensitivity or a limited ability to
react to high temperatures may be affected or
they may even suffer burn-like injuries.
Do not repeatedly switch on the seat
#
heating.
To protect against overheating, the seat heating
may be temporarily deactivated after it has been
switched on repeatedly.
The air inside the vehicle can be heated, ventila-
ted or cooled to the set temperature when the
vehicle is parked.
When the vehicle is connected to power supply
equipment, priority will be given to charging the
high-voltage battery to a specified minimum
charge.
The running time of pre-entry climate control may
be reduced in the following circumstances:
The vehicle is not connected to power supply
R
equipment.
The high-voltage battery is not fully charged.
R
With active pre-entry climate control, the charge
level of the high-voltage battery may be reduced,
even if the charging cable connector is connec-
ted.
If present, seat ventilation will be activated in
cooling and ventilation modes.
If present, the following functions will be activated
in heating mode:
Seat heating
R
Steering wheel heater
R
Mirror heater
R
Rear window heater
R
Windscreen heater
R
When the set temperature is changed, the climate
control mode will automatically be updated. It will
be switched from heating mode to ventilation or
cooling mode, from cooling mode to ventilation or
Climate control 189
heating mode or from ventilation mode to heating
or cooling mode.
Depending on the vehicle's equipment, the follow-
ing functions will also be adjusted during pre-
entry climate control if they have already been
switched on during regular vehicle operation:
Fragrancing
R
Ionisation
R
Setting pre-entry climate control for departure
time via the climate bar
Multimedia system:
Climate menu Pre-entry climate ctrl
4 5
Setting the departure time
%
The set departure times are used for the vehi-
cle's pre-entry climate control and for predic-
tions regarding the approximate state of
charge and range at the time selected. Addi-
tional information on the charging settings:
( page 229).
/
Edit departure time u.
Select
#
Select a departure time or set a new depar-
#
ture time.