Mercedes-Benz EQS 350 Operator's Manual page 427

424 Breakdown assistance
Connect the towing device to the towing eye
#
in order to load the vehicle.
% Vehicles with trailer hitch: you can also attach
the tow bar to the trailer hitch.
Switch on the power supply (
#
Put the selector lever into position i.
#
%
The selector lever may be locked in position
j in the event of electrical malfunctions. To
shift to i, provide the on-board electrical
system with power ( page 420).
/
* NOTE Possible damage to the vehicle
when loading or unloading
When loading or unloading, the vehicle must
be raised to transport level.
If the transport settings are not shown or the
Vehicle not ready for loading
played, the vehicle may not be loaded or
unloaded.
If required, raise the vehicle to transport
#
level again.
A vehicle that cannot be raised to trans-
#
port level may not be loaded or unloaded
using a ramp. Consult a qualified special-
ist workshop.
page 196).
/
& WARNING Risk of accident due to activa-
ted transport level
If the vehicle is raised to transport level, driv-
ing and driving safety systems have only limi-
message is dis-
ted availability and the view from the vehicle is
restricted.
Driving safety is severely restricted and there
is a risk of an accident!
Do not use transport level in normal road
#
operation.
Only activate and use transport level to
#
load the vehicle and when not on public
roads.
Ensure that no persons or obstacles are
#
located in the area surrounding the vehi-
cle.
Raising the vehicle to transport level
Press the G button for at least five sec-
#
onds.
Immediately press and hold the a button
#
for at least one second.
The For transport level, switch vehicle on
message is displayed.
Select vehicle transport.
#
%
The noise certification mode is intended
exclusively for the technical test organisation.
It restricts the drive power of the vehicle and
must not be used in customer operations.
Switch on the vehicle. ( page 198)
/
#
The transport settings are displayed.