Mercedes-Benz EQS 350 Operator's Manual page 236

Point remote control 5 from a distance of
#
1 cm to 8 cm towards button 1,
Press and hold button 6 of remote control
#
5 until one of the following signals appears:
Indicator lamp 4 lights up green continu-
R
ously. Programming is complete.
Indicator lamp 4 flashes green. Program-
R
ming was successful. Additionally, syn-
chronisation of the rolling code with the
door system must be carried out.
If indicator lamp 4 does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
%
The remote control for the door drive is not
included in the scope of delivery of the garage
door opener.
Synchronising the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
The vehicle as well as persons and objects are
R
2 or 3. located outside the range of movement of the
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
% Please also read the operating instructions for
the door drive.
Troubleshooting when programming the remote
control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control
#
a distance of 1 cm to 8 cm front of the inside
rearview mirror. You should test every position
for at least 25 seconds before trying another
position.
#
#
2
#
%
%
5 at various angles from
Driving and parking 233
Hold remote control 5 at the same angles at
various distances in front of the inside rear
view mirror. You should test every position for
at least 25 seconds before trying another
position.
On remote controls that transmit only for a
6
limited period, press button
control 5 again before transmission ends.
Angle the aerial line of the garage door opener
unit towards the remote control.
It is possible that older garage doors cannot
be operated using the remote control in the
inside rearview mirror even after you have
successfully performed the measures descri-
bed above. If this is the case, contact the
®
HomeLink Hotline.
Support and additional information on pro-
gramming:
®
on the HomeLink Hotline on (0) 08000
R
466 354 65 or +49 (0) 6838 907-277
on the Internet at https://
R
www.homelink.com
on remote