Fault Codes - Standard Finisher / Booklet Maker Finisher - Xerox Versant 80 Press User Manual

Fault Code Possible Cause
049-100 - 049-121 jammed paper
049-200 - 049-299 HCS sensor faults
049-300 HCS communication fault
049-700 Tabbed sheet fault
049-900 - 049-908 Sheets remain in the paper
path
049-940 HCS open door fault
049-941 Stacker Tray / Cart fault
049-945 Stacker Top Tray fault
049-960, 049-964 Stacker Tray / Cart fault
049-965 to 049-972 Stacker Full Detection fault
049-973 HCS falsely detects that the
Paper Unload button is pressed

Fault Codes - Standard Finisher / Booklet Maker Finisher

If an error caused the printing to end abnormally, or a malfunction occurred in either
the Standard Finisher or the Booklet Maker Finisher, then an error code is displayed.
If an error persists after following the listed solution, then contact your Xerox Customer
Support Center.
® ®
Xerox Versant 80 Press
User Guide
Press Problem Solving
Recommended Solution
Carefully remove all sheets and paper
scraps from the jam clearance areas.
Power Off / On the machine. If the
problem persists, contact the Customer
Support Center.
Power Off / On the machine. If the
problem persists, contact the Customer
Support Center.
Check the properties of the tabs job and
resend the job.
Check the paper path of the module
and carefully remove all sheets from
the paper path areas.
Open the HCS front door and remove
all sheets and paper scraps from jam
clearance areas. Close the front door.
Check the position of the Stacker Tray
/ Cart.
Remove paper from the Top Tray.
Remove paper from the Stacker Tray /
Cart.
Open the HCS front door and remove
any paper from the Stacker cart. Close
the door to resume operation.
Open the HCS front door and remove
any paper from the Stacker cart. Close
the door to resume operation.
14-29