Finisher Problem Solving; Problem Solving Information; Fault Codes - Standard Finisher / Booklet Maker Finisher - Xerox Versant 80 Press User Manual

Finisher Problem Solving

Problem Solving Information

Tip
Always ensure that all paper jams, including any small ripped pieces of paper, are cleared
before proceeding with your print jobs.
Note
Remedies differ according to the paper jam location. Follow the instructions displayed
to remove the jammed paper.

Fault Codes - Standard Finisher / Booklet Maker Finisher

If an error caused the printing to end abnormally, or a malfunction occurred in either
the Standard Finisher or the Booklet Maker Finisher, then an error code is displayed.
If an error persists after following the listed solution, then contact your Xerox Customer
Support Center.
Fault code Possible cause
012-100 to 012-104, Paper Jam along booklet
012-108 to 012-115, and/or folder paths
012-117 to 012-120
012-125, 012-132, The finisher malfunctioned
012-211 to 012-265,
012-282 to 012-296
012-302 Interlock Fail
012-400 Staple Waste Container near
full
012-949 Punch Waste Container is not
attached
024-931 The Staple Waste Container
is full or near full
024-932 The Staple Waste Container
is not attached
® ®
Xerox Versant 80 Press
User Guide
Standard Finisher / Booklet Maker Finisher
Recommended solution
Check for any paper jams in the paper
path and remove all sheets.
Check for any paper jams in the paper
path and remove all sheets. Power Off/On
the press and, if needed, resend the print
job. If fault persists, call for service.
Make sure the module door is fully closed.
Power Off / On the press if fault persists.
Remove and replace the staple waste
container in the finisher.
Check that the Punch Waste Container is
installed in the finisher and inserted cor-
rectly.
Remove the Staple Waste Container and
install a new one.
Check that the Staple Waste Container
is installed in the finisher and inserted
correctly.
24-11