Xerox Versant 80 Press User Manual page 243

Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)
Use this procedure to replace the OHCF feed rolls, which includes:
• Feed Roll
• Nudger Roll
• Retard Roll
Note
After you replace all of the feed rolls, contact your system administrator who will reset
the High Frequency Service Item (HFSI) usage counter for these CRU components to
zero (0).
1. Pull open the top tray of the OHCF to access the feed components.
2. Notice the feed roll compartment on the right side panel of the drawer.
3. Remove the nudger roll by pushing down on the black tab with one hand (which raises
the roll upward) and then squeezing the metal shaft on both ends with your other
hand. Lift out the nudger roll.
4. Replace the new roll by squeezing both ends of the metal shaft, and pushing down
on the black tab, insert and release the roll ends into the notches.
® ®
Xerox Versant 80 Press
User Guide
18-5