Xerox Versant 80 Press User Manual page 231
Hide thumbs
Also See for Versant 80 Press:
- System administration manual (230 pages) ,
- Installation manual (62 pages) ,
- Customer expectation & installation manual (48 pages)
Table of Contents
Advertisement
Fault Area
Fault Code
Tray 6
078-100,
078-101,
078-102,
078-103
Tray 7
078-150,
078-151
Tray 6
078-102
Tray 7
078-156
Trays 6 and 7
078-2[00-
99], 078-
3[00-99],
078-4[00-
99], 078-
6[00-99],
078-9[00-
99]
®
®
Xerox
Versant
80 Press
User Guide
1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)
Possible Cause
Pre-registration sensor
jam; during paper trans-
portation, feed sensor is
not turned on within peri-
od of time paper is trans-
porting from tray
Pre-registration or feed
sensor jam during paper
transportation from Tray
7
Regi sensor not turned on
fault during paper trans-
portation from Tray 6
Regi sensor not turned on
fault during paper trans-
portation from Tray 7
General tray malfunction
Recommended Solution
Perform the following in this order:
1.
Remove or clear any
jammed paper.
2.
Replace and fan the paper
in tray.
3.
Replace the OHCF Feed
Rolls; refer to
Replacing the
OHCF Feed Rolls (Trays 6
and
7).
Perform the following in this order:
1.
Remove or clear any
jammed paper.
2.
Replace and fan the paper
in tray.
3.
Replace the OHCF Feed
Rolls; refer to
Replacing the
OHCF Feed Rolls (Trays 6
and
7).
Perform the following in this order:
1.
Remove or clear any
jammed paper.
2.
Replace and fan the paper
in tray.
3.
Power Off / On the press.
4.
If problem still persists,
contact the Customer Sup-
port Center.
17-7
Hide quick links:
Advertisement
Table of Contents
