Xerox Versant 80 Press User Manual page 186

Press Problem Solving
Fault Area Fault Code
Tray 8 178-112
Tray 9 178-113
Tray 9 178-150, 178-
151
Trays 8, 9 and 178-217, 178-
Bypass 218, 178-[224-
229], 178-230,
178-232, 178-
250, 178-251,
178-[260-281],
178-[285-291],
178-[293-294],
178-298
Trays 8 and 9 178-304
Trays 8 and 9 178-400 - 178-
405
14-24
Possible Cause Recommended Solution
Gate sensor not Perform the following in this order:
turned on fault during 1. Remove or clear any jammed
paper transportation
from Tray 8
2. Replace and fan the paper in
3. Power Off / On the press.
4. If problem still persists, contact
Gate sensor not Perform the following in this order:
turned on fault during 1. Remove or clear any jammed
paper transportation
from Tray 9
2. Replace and fan the paper in
3. Power Off / On the press.
4. If problem still persists, contact
Pre-registration or Perform the following in this order:
feed sensor jam dur- 1. Remove or clear any jammed
ing paper transporta-
tion from Tray 9
2. Replace and fan the paper in
3. Replace the OHCF Feed Rolls;
General tray malfunc- 1. Remove or clear any jammed
tion
2. Replace and fan the paper in
3. Power Off / On the press.
4. If problem still persists, contact
OHCF Front Door Close the front door / cover of the OHCF.
Open
An OHCF feed, nudger, Replace the feed rolls; refer to
or retard roll is near the OHCF Feed Rolls for the OHCF
end of life (Trays 8 and 9)
paper.
tray.
the Customer Support Center.
paper.
tray.
the Customer Support Center.
paper.
tray.
refer to Replacing the OHCF
Feed Rolls for the OHCF (Trays
8 and 9).
paper.
tray.
the Customer Support Center.
Replacing
® ®
Xerox Versant 80 Press
User Guide