Note
The term Book Pressing is used synonymously with the terms Square Fold or Square
Folding.
Square Fold Options
The Square Fold (Book Pressing) feature can be switched on or off based on user
preference.
Note
Run one or more test prints before running large jobs.
The Square Fold options include the following:
• On / Off: Select On to use the Square Fold / Book Pressing feature. The default setting
is Off.
• Pressure Applied: Select one of five options depending on your requirements for the
finished booklet job.
- Select the +2 / Higher / High 2 setting when you want the most amount of
pressure applied to the spine of the booklet. The more pressure applied, the more
square the booklet spine will be. The greatest amount of pressure that can be
applied to the booklet is +2.
- Select the +1 / High / High 1 setting when you want a greater amount of pressure
applied to the spine of the booklet, but not as much as the +2 setting uses.
- Auto / Normal is the default setting and is used for most jobs.
- Select the -1 / Low / Low 1 setting when you want less pressure applied to the
spine of the booklet. The less pressure applied to the booklet, the more rounded
the booklet spine will be.
- Select the -2 / Lower / Low 2 setting when your finished booklet is five pages or
less and on lightweight paper (100 gsm or lower). The least amount of pressure
that can be applied to the booklet is -2.
Trimmer Feature
The Trimmer feature is available when the press is connected to both a finisher with a
booklet maker and the SquareFold Trimmer Module. The Trimmer feature can be selected
/ accessed from your computer print driver, the press User Interface (UI), or from the
print server.
®
®
Xerox
Versant
80 Press
User Guide
SquareFold Trimmer Module
25-5