Loading Media In The Bypass (Tray 5); Loading Paper In The Bypass (Tray 5) - Xerox Versant 80 Press User Manual

8. From the Paper Tray settings/Tray Properties window, enter the correct paper
information, including size, type, weight and, if necessary, paper curl and/or alignment
option.
9. Select Confirm or OK to save the information and close the Paper Tray settings/Tray
Properties window.

Loading Media in the Bypass (Tray 5)

Note
If any optional feeding devices are attached, the Bypass (Tray 5) is installed above or
on top of that feeding device.
This tray is used primarily when using a small quantity and special media (such as
envelopes). Review the following tips when using the Bypass (Tray 5):
• Verify the stock loaded in the tray with the Paper Tray settings/Tray Properties window
on the UI
• Load a maximum of 280 sheets of 20 lb. / 75 gsm paper
• Do not load mixed-size paper into the Bypass Tray
• Do not load materials above the MAX line as indicated on the tray

Loading Paper in the Bypass (Tray 5)

Note
The following prodecure shows the Bypass (Tray 5) located on top of the 2-Tray OHCF.
1. Gently extend the Bypass tray (Tray 5) as necessary to accommodate the paper.
2. Hold the center of the paper guides and slide them to the desired paper size.
3. Select the appropriate paper stock for your print/copy job.
4. Open the ream of paper with the seam side facing up.
® ®
Xerox Versant 80 Press
User Guide
Paper and Media
3-5