Xerox Versant 80 Press User Manual page 175

Fault Area Fault code
016-710
016-712
016-721
016-735
016-738
016-739
016-740
016-748
016-755
® ®
Xerox Versant 80 Press
User Guide
Possible cause
Delayed print documents
cannot be registered.
The machine is unable to
process size, because the
specified document area is
too small.
An error occurred during
print processing. Probable
causes are as follows:
• Printing was instructed
by automatic tray selec-
tion when Paper Type
Priority is set to Auto-
matic Tray Switching >
Off for all paper in the
Common Service Set-
tings.
• ESC/P command error
Attempted to print Job
Template List while updat-
ing the job template.
Booklet Creation is not ap-
plied to the specified paper.
The specified document and
paper size are an unauthor-
ized combination.
Booklet Creation is not ap-
plied to the specified paper
tray.
Printing is not possible due
to insufficient hard disk
space.
Attempted to process PDF
file which was specified to
printing prohibited.
Press Problem Solving
Recommended solution
Check print options and spe-
cify the print data again. If
the hard disk is malfunction-
ing, contact your Xerox Cus-
tomer Support Center.
Increase resolution or scan
area size.
Perform one of the following:
• When printing by auto-
matic tray selection, set
one of the paper types to
a setting other than
Automatic Tray Switch-
ing > Off in Paper Type
Priority.
• Check print data.
Retry printing after waiting
for a period.
Specify the printable paper
size for booklet creation.
Specify the combination of
the printable document and
paper size for booklet cre-
ation.
Specify the printable paper
tray for booklet creation.
Reduce the number of pages
of print data, for example, by
dividing up the print data or
printing one copy at a time
when making multiple copies.
Cancel the printing prohibited
specification using Adobe
Reader, and try to print again.
14-13