Die Stop Position; Die Stop Position Guide For Us Paper Sizes - Xerox Versant 80 Press User Manual

GBC AdvancedPunch Pro

Die Stop Position

On some of the AdvancedPunch Pro die sets there is an adjustable die stop which is used
to change the hole position for the die set for certain sheet sizes, as shown in the following
illustration.
Note
For die sets without a die stop knob there is no die stop position adjustment necessary.
1. Die Stop Handle Label:
Common paper sizes are shown on the die stop handle label below the die stop
knob.
2. Die Stop Knob:
For units with a die stop knob, the die stop must be set to the correct position or the
punched holes will not be centered on the sheet.
3. Position A:
This is when the arrow on the die stop knob points down towards the handle and
lines up with the lower arrow on the die stop handle label.
4. Position B:
This is when the arrow on the die stop knob points to the side and lines up with the
side arrow on the die stop handle label.
Refer to these tables:

Die Stop Position Guide for US Paper Sizes

Guide for ISO Paper Sizes.
Die Stop Position Guide for US Paper Sizes
US Paper Coil Round
Size
Die Stop Position Based On Paper Size or Orientation
LTR LEF B
LTR SEF B
22-10
Wire 2:1 Wire 3:1 CombBind
Round Round
A A A
A B A
and Die Stop Position
Wire 2:1 Wire 3:1
Square Square
A A
A B
® ®
Xerox Versant 80 Press
User Guide