Omron CompoNet MX2 Series User Manual page 63

Frequency Reference/RUN Command Settings
Inverter parameters A001 and A002 set Frequency reference selection and RUN command selection.
When P046 is set to 0 (Basic Speed I/O), 1 (Extended Speed I/O), or 7 (Extended Speed and Accelera-
tion Control), set these parameters according to the following table.
 Destination Selection Parameter Settings
Parameter
A001
A002
 Destination Selection Parameter Settings
Parameter
A001
A002
Precautions for Correct Use Precautions for Correct Use
To switch the Control Method using the REF (Net.Ref.) or CTR (Net.Ctrl.) bit signal, set as fol-
lows.
CTR
REF
• Set the Control Method to which you want to switch in parameter A001/A002.
Restarting the Inverter
Be sure to cycle the power supply of the MX2/RX-series Inverter to enable the changes.
Precautions for Correct Use Precautions for Correct Use
• Be sure that the POWER LED indicator is not lit when cycling the power supply of the
MX2/RX-series Inverter. Note that the time until the light turns off varies with the inverter
model.
• Some CompoNet Master Units in market may send Idle messages during specific events
(start-up, PLC program mode, etc). In this case, consider to set Operation at Idle Mode
Detection Setting (P048) to 02 (Ignore).
CompoNet Communications Unit User's Manual (I582-E1)
Description
1st Frequency Reference Selection
1st RUN Command Selection
Description
1st Frequency Reference Selection
1st RUN Command Selection
Bit Name
Net.Ctrl.
Net.Ref.
04: Option
05: Option 2
Description
0: Follow the setting of parameter A002.
1: Follow the reference from network.
0: Follow the setting of parameter A001.
1: Follow the reference from network.
3 Network Startup
Setting
Setting
3
3 - 5