Komatsu Galeo BR380JG-1E0 Shop Manual page 808

50 Disassembly and assembly
Assembly
1. Assembly of clevis
1) Clean the part to fit bushing (12).
2
Fitting part:
2) Using tool (11) and a hammer, press fit
bushing (12).
a Adjusting the center of the bushing,
press fit the bushing slowly.
3) Install ring (10) with snap ring pliers.
BR380JG-1E0
Anti-seizure compound
(Molybdenum spray, etc.)
2. Installation of clevis and flange
1) Install seals (4), (5), (6), and (7).
a Take care not to mistake the positions
of the seal and ring or the direction of
the lip.
a If there is rust or a flaw on the fitting
part, remove it.
2) Install flange (2) with the hook spanner.
2
Fitting part:
Same oil as currently applied
one, grease, etc. (Apply thinly)
2
Threaded part:
Anti-seizure compound
(Molybdenum spray, etc.)
a Tighten the flange slowly so that it will
not be seized.
a Retighten the flange by using a hammer.
3
Flange: 980 Nm {100 kgm}
SEN02738-00
13