30 Testing and adjusting
Inspection of frame at head pulley portion
If the frame was once deformed at the belt conveyor head pulley portion, or any of the parts was removed
and installed in the past, carry out the following inspection and make adjustments or replace a parts, if nec-
essary.
1.
Operate the belt conveyor without load.
2.
Check the frame at portion (A) visually, and if the frame is found to sway sideways, it means the frame
needs to be replaced with a new one.
If the frame does not show such sway, there is no need for the replacement.
a This sideways sway can be visually confirmed when an amount of sway is over 3 mm.
BR380JG-1E0
SEN02305-01
43