Table of Contents
Advertisement
30 Testing and adjusting
4)
After inputting the desired O.S.S. clear-
ance, press input confirmation switch (6)
to set the input value.
a The set value is saved and is displayed when
the next adjustment is made to the clearance.
If that value is to be used as it is, there is no
need to input the set value again.
a If it is desired to abort the setting of the O.S.S.
clearance, press return switch (7). This will
return the set value to the original setting.
6.
Adjust the clearance.
1)
Use UP switch (4) or DOWN switch (5) to
move the cursor on the screen display to
position (C).
2)
Press input confirmation switch (6) to
complete the preparations.
"|" lamp (C) flashes.
3)
Press input confirmation switch (6) again
to carry out the adjustment.
"|" lamp (C) lights up and the automatic
adjustment is carried out.
BR380JG-1E0
7.
"|" lamp (C) goes out to show that the clear-
ance adjustment is completed.
Automatic adjustment is carried out with the
q
following procedure.
1)
The movable swing jaw plate to the fixed
tooth side and the crusher clearance
closes. When this happens, portion (E) on
the machine monitor flashes.
2)
When the swing jaw plate contacts the
fixed tooth, the buzzer inside the machine
monitor sounds, and crusher actual clear-
ance monitor display value (F) is as
shown as 0.
SEN02305-01
7
Advertisement
Table of Contents
Troubleshooting
