Table of Contents
Advertisement
SEN02305-01
Adjusting clearance in A (automatic) mode
1.
Start the engine.
2.
Set fuel control dial (1) to the low idle (MIN)
position.
3.
Set mode selector switch (2) to INSPECTION
(c) position. The machine monitor switches to
the normal inspection screen.
6
4.
Set clearance adjustment selector switch (3) to
position (A) (automatic).
5.
Check that clearance adjustment monitor (D)
of the machine monitor is set to (A) (automatic)
mode, then input the OSS clearance (A) to be
adjusted to the machine monitor in the follow-
ing order.
1)
Use UP switch (4) or DOWN switch (5) to
move the cursor on the screen display to
position (A).
2)
Press input confirmation switch (6). (A)
starts flashing and numeral input window
(B) is displayed at the top left of the
screen.
3)
Use UP switch (4) or DOWN switch (5) to
increase or decrease the value on the dis-
play and adjust to give the desired set
value.
The numerical value can be set in units of
1 mm in a range of 50 to 150 mm.
If the UP switch (4) or DOWN switch (5) is
kept pressed continuously, the set value will
increase or decrease in units of 10 mm .
30 Testing and adjusting
BR380JG-1E0
Advertisement
Table of Contents
Troubleshooting
