Komatsu Galeo BR380JG-1E0 Shop Manual page 386

30 Testing and adjusting
2) In case the belt tension is not appropriate;
Adjust the belt tension in the same way as
mentioned above. At that time, adjust the
belt so that it will have a clearance of 30 to
40 mm from the lower surface of the mag-
net on the main body.
3) In case debris are stuck at the backside of
the belt;
Remove them as soon as found, since
they can cause a damage on the belt or
the pulley.
4) If the belt or any related part is broken,
replace it immediately.
BR380JG-1E0
Adjusting clearance from conveyor
The clearance between the surface of the conveyor
belt and the magnet when the machine is shipped
from the factory is approx. 350 mm at both (A) and
(B) when the primary conveyor height is at the fixed
position for crushing reinforced concrete.
Change as necessary according to the crusher dis-
charge clearance and condition. For details of the
fixed position for crushing reinforced concrete, see
"Preparations for primary conveyor in Operation
and maintenance manual".
Front (P): Change position of magnetic separator
chain (1) to adjust, and fit on magnetic
separator frame hook (2).
Rear (Q): Change position of magnetic separator
bracket hole (5) and magnetic separator
frame hole (4) to adjust, then secure
with pin (3).
SEN02305-01
45