Table of Contents
Advertisement
30 Testing and adjusting
5)
Loosen spring holder push bolt (5) so that
dimension (B) becomes 15 mm, then
tighten locknut (4).
6)
Repeat the procedure in Step 3) to check
that spring holder (6) is being pushed in to
the correct position. If it is not the specified
value, adjust again.
Replacement of toggle plate
1.
Secure the crusher inspection hatch in the
open position.
2.
Remove the dust prevention rubber plate at
the side of the crusher. (left and right)
BR380JG-1E0
3.
Wrap a nylon sling around toggle plate (1) and
sling it.
4.
Check that there is no one inside the machine,
then start the engine.
5.
Set mode selector switch (3) to the inspection
position.
6.
Attach a warning tag to announce to those
concerned that the machine is now worked on.
7.
Press crusher clearance decrease switch (4)
on the control box, and move the fixed link for-
ward until the fixed jaw plate contacts the fixed
jaw plate.
SEN02305-01
31
Advertisement
Table of Contents
Troubleshooting
