Komatsu Galeo BR380JG-1E0 Shop Manual page 359

SEN02305-01
Replacement of cheek plate
1. Use an air gun or wire brush to remove the
sand or soil clogging lifting hole (3) of top
cheek plate (1).
2. Loosen cheek plate mounting bolt (4). Next,
with the bolt loosened, tighten locknut (5) again.
Tools to use
Wrench: Accessory tool No. 1
Handle: Accessory tool No. 3
Extension: Accessory tool No. 4
Socket: Accessory tool No. 5
Wrench: Accessory tool No. 7
Pipe: Accessory tool No. 8
k
For details of the accessory tool, see
"Crusher accessory tool" in Mainte-
nance volume of the operation and
maintenance manual.
18
3. Fit the tool supplied with the machine to the lift-
ing hole, then lift up vertically. If the load is at
an angle, it may be difficult to remove.
Tools to use
Hook: Accessory tool No. 10
k
For details of the accessory tool, see
"Crusher accessory tool" in Mainte-
nance volume of the operation and
maintenance manual.
30 Testing and adjusting
BR380JG-1E0