Komatsu Galeo BR380JG-1E0 Shop Manual page 803

SEN02738-00
8. Fully loosen tension springs (2) (M42 on both
sides).
k
It is very dangerous to go to the follow-
ing step without fully loosening ten-
sion springs (2). Accordingly, remove
tension spring nuts (9) from the rod.
9. Pass the wire through the hole in the bottom of
the swing jaw (6), then use a chain block to pull
the crusher case and the track frame and fix
them in position.
10. Start the engine.
11. Press the crusher clearance increase switch
(5) on the control box to pull the fixing link
slowly.
8
50 Disassembly and assembly
12. Stop the engine.
13. Take out toggle plate (1).
4
Toggle plate: 101 kg
14. Wind the nylon sling onto new toggle plate (1).
Lower the toggle plate to set it to the center of
the seat on the fixing link side.
15. Start the engine.
16. Set mode selector switch (3) in the inspection
position.
k
Put a warning tag to the starting switch
t o n o t i f y t h e p e r so n s a r ou nd t h e
machine that you are working on the
machine.
BR380JG-1E0