Editing The Simulation Display; Blank Display; Showing And Hiding The Tool Path - Siemens SINUMERIK 840D sl Universal Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
8.6
Editing the simulation display
8.6.1
Blank display
You have the option of replacing the blank defined in the program or to define a blank for
programs in which a blank definition cannot be inserted.
Note
The unmachined part can only be entered if simulation or simultaneous recording is in the reset
state.
Procedure
8.6.2
Showing and hiding the tool path
The path display follows the programmed tool path of the selected program. The path is
continuously updated as a function of the tool movement. The tool paths can be shown or
hidden as required.
Procedure
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
1.
The simulation or the simultaneous recording is started.
2.
Press the ">>" and "Blank" softkeys.
The "Blank Input" windows opens and displays the pre-assigned values.
3.
Enter the desired values for the dimensions.
4.
Press the "Accept" softkey to confirm your entries. The newly defined
workpiece is displayed.
1.
The simulation or the simultaneous recording is started.
2.
Press the ">>" softkey.
The tool paths are displayed in the active view.
3.
Press the softkey to hide the tool paths.
The tool paths are still generated in the background and can be shown
again by pressing the softkey again.
4.
Press the "'Delete tool path" softkey.
All of the tool paths recorded up until now are deleted.
Simulating machining
8.6 Editing the simulation display
227
Advertisement
Table of Contents
