Defining An Interruption Point As Search Target; Entering The Search Target Via Search Pointer - Siemens SINUMERIK 840D sl Universal Operating Manual

7.7.4

Defining an interruption point as search target

Requirement
A program was selected in "AUTO" mode and interrupted during execution through CYCLE STOP
or RESET.
Procedure
7.7.5

Entering the search target via search pointer

Enter the program point which you would like to proceed to in the "Search Pointer" window.
Requirement
The program is selected and the controller is in the reset state.
Screen form
Each line represents one program level. The actual number of levels in the program depends on
the nesting depth of the program.
Level 1 always corresponds to the main program and all other levels correspond to subprograms.
You must enter the target in the line of the window corresponding to the program level in which
the target is located.
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
1. Press the "Block search" softkey.
2. Press the "Interrupt point" softkey.
The interruption point is loaded.
3. If the "Higher level" and "Lower level" softkeys are available, use these to
change the program level.
4. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into account.
The search screen closes.
The current block will be displayed in the "Program" window as soon as the
target is found.
5. Press the <CYCLE START> key twice.
The execution will continue from the interruption point.
Machining the workpiece
7.7 Starting execution at a specific point
151