Reactivating A Tool - Siemens SINUMERIK 840D sl Universal Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Tool management
12.6 Tool wear
Icon/
Marking
Yellow triangle pointing
upward
Green border
Magazine/location number
Green double arrow
Gray double arrow
(configurable)
Red "X"
Procedure
See also
Changing a tool type (Page 302)
12.6.1
Reactivating a tool
You can replace disabled tools or make them ready for use again.
Requirements
In order to reactivate a tool, the monitoring function must be activated and a setpoint must be
stored.
290
1.
Select the "Parameter" operating area.
2.
Press the "Tool wear" softkey.
Meaning
The tool is in a special state.
Place the cursor on the marked tool. A tooltip provides a short
description.
The tool is preselected.
The magazine location is positioned at the change position.
The magazine location is positioned at the loading position.
The magazine location is disabled.
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Universal
Advertisement
Table of Contents
